T8830 Output module 40 channel digital 24/48VDC ICS TRIPLEX

T8830 Output module 40 channel digital 24/48VDC ICS TRIPLEX

The following enhancements are included in this release.
 Increase Variable Bindings Memory
T8830  The Variable Bindings (KVB) memory has been increased in sizefrom 64 K to 128 K. This will allow you to increase the number of variable bindings that you can set up between controllers in an application.
 New Workbench license for 5 Users, Unlimited ControllersNew license option T9084U is available: this is an AADvanceWorkbench license for 5 Users and no limit to the number ofcontrollers. It is only available as a USB license option: it will workwith Windows XP Service Pack 3; Windows Vista; Windows 7 andServer 2003 in both 32-bit and 64-bit versions.

The following problems and anomalies have been corrected in this release.
 Digital Output Module Shutting Down
T8830  Under certain operating and environmental conditions noise can be
present of one of the digital output module voltage rails. These
voltage rails are sampled to ensure that they are within a specific
tolerance; but the noise occasionally caused the monitoring circuit to
report an over-voltage, resulting in the DO module shutting down.
An internal filter has been improved that reduces the effect of the
noise and prevents the module from shutting down.
 I/O initialization stalled – TN30051-01 (answer id. 544046)
If, during a controller start-up an I/O module failure occurs it can
stop the I/O initialization. As a result, the controller start-up process
fails to complete, leaving the application program suspended.
Changes to the controller start-up have been made that prevents this
from occurring.
 System power up with a 48 module configuration
The maximum number of I/O modules supported by an AADvance
controller is 48. Certain configurations, particularly when the
majority is Digital Output Modules, can result in a system not
starting-up correctly after a power cycle. Changes to the controller
start-up have been made to prevent this from occurring.
 Processor loss of synchronization
In dual processor configurations it was possible under certain
conditions for the two processors to lose synchronization, but
continue to run asynchronously. Although the I/O still went to its
fail-safe mode, it was possible for any binding data to be incorrect.
Changes to the controller have been made to prevent this from
occurring.
 Spurious Soft Error Detection (SED) faults – TN30056-01
(answer id: 564815)
Each AADvance module uses one or more FPGA’s to provide the
communication interface between the processor and the I/O
modules. The manufacturer of the FPGA used in AADvance
released a Product Notification identifying that this device could
spuriously generate SED errors. The FPGA manufacturers
recommended changes have been made to the controller to prevent
this from occurring.
 Processors lost synchronization after an on-line update
It is possible that on-line updates to a large system with more than 37
I/O modules installed can cause the processors to lose
synchronization. Changes to the controller have been made to
prevent this from occurring.
 Loss of SNCP Kernel Variable Bindings (KVB) communication
Under certain conditions it was possible for both links of dual SNCP
bindings configuration to fail. Changes to the controller have been
made to prevent this from happening.